Correct installation method of horizontal fluidized bed dryer

Hot air transfers heat energy to wet materials through convection, carrying it away during vaporization. Besides the machine itself, the system includes auxiliary equipment. Horizontal fluidized bed dryers have relatively high efficiency, and installation is crucial.

 

**XF Series Horizontal Fluidized Bed Dryer Installation Method:**

 

1. After positioning the equipment according to the plant and process conditions, prepare the embedded plates, foundations, and pre-drilled holes for the vibrating fluidized bed, fan, cyclone separator, etc. The ground must be level, and the foundation must ensure the stability and stability of the main unit during operation.

 

2. Connect the inlet and outlet air ducts to the inlet and outlet air pipes using flexible hoses (can be made from canvas). Install the two vibrating motors in parallel at a certain angle, controlling them with the same forward/reverse switch. Open the eccentric block covers at both ends of the vibrating motors, connect the power supply to the motors, and observe the rotation direction of both motors.

 

3. Thoroughly and carefully check all fasteners for looseness. Run the machine under no-load for two minutes to observe whether the equipment runs smoothly and whether there is any abnormal vibration or noise. Also test whether the current in each phase of the vibratory motor is balanced and whether the motor temperature rise is within the allowable range (see the vibratory motor instruction manual for details).

The system operates under slight negative pressure or negative pressure and is sealed, preventing dust from flying and ensuring a clean working environment. The flow-through parts are made of SUS304 material with smooth structural transitions. The main unit is equipped with a sanitary quick-opening inlet and a cleaning drain ball valve for easy cleaning and intermittent operation.